EATON CUTLER HAMMER C320PRP2 Lighting Contactor, Double Power Pole, Freedom Series
Eaton’s Cutler-Hammer Mechanically Held Lighting Contactors are designed for industrial, commercial and outdoor lighting applications where efficient control is required. The mechanically held operation ensures that the contactor will not switch to OFF during control power failure. It also ensures the removal of coil from the circuit for noise-free operation and the elimination of all coil losses after the contactor is latched. The control module microprocessor validates the control signal before operation, so it will not respond to momentary voltage spikes of noise. The operation command has a built-in .4 sec delay to avoid multiple short-term commands that can cause contact fatigue or failure. Also, the feedback loop prevents the contactor from getting out of sequence with switches, even after power failures.
Applications
The mechanically held lighting contactor provides effective control in applications such as office buildings, industrial plants, hospitals, stadiums, airports, etc. They are ideal for applications that require quiet, energy-efficient operation. Designed to handle different load types:
- Tungsten (Incandescent Filament)
- Ballast (Fluorescent and Mercury Arc)
- High-Intensity Discharge (HID)
- Non-Motor AC Resistive
- Single- and Three-Phase Motor Ratings
Features
- 30 Amp Power Pole Rating
- Up to 12 Poles Maximum
- Low Magnetic Noise Results in Quiet Operation
- Low Input VA Permits Long Wire Runs
- Come in a Wide Range of Input Voltages and with Coils from 24-277 VAC and 12-24 VDC
- Power Poles Latch Easily onto the Base, and Designating Them as NO or NC is a Simple Matter of Left or Right Positioning (Additional Poles, Either NO or NC, May Be Easily Added at Any Time)
The power pole kits are designed for use in the lighting contactor C320CN series. Power poles are available in both single pole (C320PRP1) and double pole (C320PRP2) versions. A maximum of twelve poles is offered. When installed, the power poles can be configured as either normally open “NO” or normally closed “NC” in position “1” to “4” on the lighting contactor base, while positions “5” and “6” can be configured as “NO” power pole only.